Re: MiNT 1.05 and Minix fs 060

[Bjarne Pohlers <bjarne@GOEDEL.UNI-MUENSTER.DE>]

|>> 
|>> Hello there!
|>> 
|>> I've just applied Eric's patches to MiNT 1.04, and compiled it. Works well,
|>> except the Minix fs. I see the partition (32MB), but an ls on it shows no
|>> files. But when I run fsck on it, everything checks out O.K., and THEN MiNT
|>> recognises it correctly, i.e. all my files on it can be accessed normally.
|>> 
|>> Anyone else experienced this? I cross-compiled on a sun using GCC 2.2.2,
|>> optimization -O and -O2 -fomit-frame-pointer. Both versions show exactly
|>> the same behaviour. Oh, yes, they are 030-only without mem-prot (mintnp.prg
 >)
|>> since my graphics card can't stand it...
|>>

|>I haven't tried MiNT 1.05 and the new Minixfs yet, but, just as a general
|>note, you shouldn't use -fomit-frame-pointer on 68K processors with
|>GCC 2.X, because it generates bad code on some occasions! Perhaps you
|>should try again without that option...

Hmm, I do not have any problems with a -fomit-frame-pointer compiled
MiNT or minixfs - but I use GCC 2.3.3. Joerg: maybe you should upgrade
to GCC 2.3.3?
--
Bjarne Pohlers                 | Institut  fuer  Numerische und  instrumentelle
<bjarne@math.uni-muenster.de>  |       Mathematik (Informatik) der WWU Muenster
CREN: POHLERB AT DMSWWU1A      | Einsteinstrasse 62 | W-4400 Muenster | Germany
MAUS: Bjarne Pohlers @ MS2     | Phone: (x49) 251 - 83 37 54