Re: [MiNT] [PATCH] Build fails

[Miro Kropáček <miro.kropacek@gmail.com>]

On the other hand, Alan should confirm that because if the code below that is not a reset then it will seriously break things :)

On Wed, Dec 11, 2013 at 6:12 PM, Miro Kropáček <miro.kropacek@gmail.com> wrote:

On Wed, Dec 11, 2013 at 5:57 PM, Vincent Rivière <vincent.riviere@freesbee.fr> wrote:

But if LAN_DATA is a hardware register, reading it (even if the value is not used) might be very important.
So you should check twice before removing that code.

It's a data register. What I wasn't sure about is the reset following that code (*LAN_POINTER = 0x04e0) so I left it there. This shouldn't do any harm, it's a leftover from checking destination address or so which was removed by Alan because it's not task for a driver.

--
MiKRO / Mystic Bytes
http://mikro.atari.org

--
MiKRO / Mystic Bytes
http://mikro.atari.org